List Of Parts And Contents - Transax Ingenico iWL252 Installation Instructions Manual

3. Terminal Installation (essential)
Your new iWL252 Bluetooth payment terminal has the ability to process transactions over an
analogue telephone network or broadband / computer network. The following section will
guide you through the process of initial set-up, should you require more information, please
refer to your iWL200 Series Terminal User Guide starting in Section 4, (page 6) this can be
found in the Merchant Zone at www.transaxmerchantservices.co.uk
Unpack all parts of your terminal and check them against the List of Parts and Contents in
Section 1 of these Installation Instructions.
Telephone Lead Connection
Open the back of the cradle via the two catches on it's underside. Connect the TERMINAL
TELEPHONE LEAD (using the clear plastic end) into the communication port marked
.
(DO NOT use the port maked COM1 or COM0). The white plastic end of your telephone lead
connects into your analogue telephone socket.
Alternatively...
IP / Broadband Cable Connection
Connect the IP / BROADBAND CABLE into the communication port on the rear of the cradle
(DO NOT use the port maked COM1 or COM0). The opposite end of the IP/Broadband Cable
will plug into a spare ethernet socket on your Broadband router /switch / computer network.
Please note that your payment terminal can be cabled for either but not both of the
above options.
Paper Roll Loading
The paper roll is stored in a 'well' at the top of the terminal, above the screen. To load paper,
lift the cover release catch by pulling it towards you and the lid will open. Drop a new PAPER
ROLL into the 'well' ensuring that the end of the roll is towards the front. Pull the end of the
roll up, so that the smooth, shiny side of the paper is facing you - with some protruding out of
the top of the terminal. Carefully close the lid, it will lock into place. To prolong the life of your
paper roll please ensure that when tearing receipt copies from the terminal, that the paper is
torn from left to right, across the screen.
Battery Insertion (if required)
Carefully remove the plastic cover on the underside of the terminal and connect the white
battery connector onto the 3 pins beneath the printer. Ensure that the clip on the front of
the battery connector faces forward - the terminal should power up. Replace the plastic
cover. Your battery should be charged for 3 hours prior to use. To do this, connect your
power lead into the rear of the charging cradle and connect to the mains power supply.
Place your terminal on the cradle to start charging.
Connecting Power Leads
Connect the POWER LEAD to the cradle. Insert the electric plug into a power socket.
Place the terminal onto the cradle. Your terminal will power up as soon as it is connected. It
is crucial that your terminal has been connected to either an analogue telephone or an IP /
Broadband network BEFORE the terminal is placed on the cradle.
The terminal has already been configured for your use including your merchant number.
The following sections will allow you to change pre-configured settings and understand the
functions of the terminal.
TMS, iWL252 Bluetooth (PSTN/IP), Read Me First Installation Instructions, 1215 v2