Table of Contents
Advertisement
Operating Instructions
NOTE // When one of the control knobs is
activated, sparks are generated on all burners of
the cooktop simultaneously.
CAUTION // If the flame is extinguished
unintentionally, turn off the gas with the control
knob, wait for at least 30 seconds for the gas to
dissipate and try to light it again.
3. Switching off
To turn off a burner, simply turn the knob
clockwise until it stops under the OFF symbol " ".
This stops the flow of gas and the flame goes out.
4. Interruption to the electricity
supply
In the event of a power cut the flame can be
ignited with a match by following the steps:
1. Press the corresponding knob of the burner
you are about to use all the way in, then
turn it anti-clockwise until you reach the
'Strongest Flame' symbol.
2. While pressing the control knob in, light the
gas at the burner with a match.
3. Keep the knob pressed in for a few seconds
after the flame ignites.
5. Regulating the flame
IMPORTANT // Adjust the flame intensity so that
it does not spread out beyond the side of the pan.
The tips of the flames are much hotter than the
Page 8
centre, so they should stay beneath the pan base
for a best efficiency and a lower risk of injuries
and damages on pan handles.
The flame can be regulated for any level between
the strongest and weakest flame symbols.
•
Cookware should be positioned aligned
with the centre of the burner.
•
Do not use round-bottomed pans (eg.
Woks) without an appropriate wok support
recommended by the manufacturer.
6. Flame failure device
This appliance is fitted with a thermo-electric
flame failure safety device that cuts off the
supply of gas to a burner if the flame goes out,
for example, when water boils over the burners
or sudden draughts occur.
The flame failure device operates
independently from the electricity supply. This
means that it will still work if the cooktop is
used during a power cut.
Gas Hob User Manual
Hide quick links:
Advertisement
Table of Contents
