Platinum AUPL-GF61SS User Manual page 16

Installation
Gas Conversion – Natural Gas / ULPG
This appliance is factory fitted with Natural
Gas Injectors (burner nozzles) and is also
supplied with a ULPG conversion kit. To adapt
the cooktop to a different type of gas, the gas
injectors must be changed as follows:
1. Remove the pan supports (trivets), burner
caps and burner diffusers.
2. Unscrew the injectors using a 7mm socket
wrench.
3. Replace the injectors with those supplied
corresponding to the gas available (see
burner and injector characteristics table)
IMPORTANT // On completing the operation,
replace the old gas label with the one showing the
new type of gas; the sticker is available in the User
Manual package
Adjusting the minimum flame intensity
The minimum flame intensity is adjusted at
the factory. However, when the gas injectors
are replaced or in special mains pressure
conditions, it may be necessary to readjust the
intensity of the minimum flame.
Page 16
Follow the operations below for each burner in
order to adjust the minimum flame intensities:
1. Light the burner.
2. Turn the knob control anti-clockwise to the
weakest flame.
3. Remove the knob from the valve shaft (and
gasket if there is one).
4. Use a thin blade screwdriver to turn the
bypass screw located on top of the gas
valve shaft.
ULPG
Gently turn the bypass screw clockwise until
it is completely tightened.
Natural Gas
Gently turn the bypass screw clockwise
until it is completely tightened, then slowly
turn it anti-clockwise for adjustment of the
flame. The correct length of the flame is
around 3 to 4mm.
5. Put the knob back on and test if the flame
goes out when quickly turning the knob
control from the strongest flame to the
weakest flame positions.
6. For burners with flame failure device, make
sure that the regulation obtained is sufficient
to maintain the thermocouple activated when
operating with the weakest flame. If it is not,
increase the minimum flame intensity.
Gas Hob User Manual