Diverter Valve; Rubber, Drive Shaft; Power Steering Piping; Wiring - Shibaura ST318 Workshop Manual

12. Diverter valve

➀ Remove the banjo bolt and disconnect the sump
return from the diverter valve disconnect the other
end from the sump.
➁ Disconnect the system pressure line from the
diverter valve and the lift cover.

13. Rubber, drive shaft

➀ Loosen the clamps on the front wheel drive shaft
rubber boot and slide the boot rearward to gain
access to the shaft universal joint.
➁ Remove the universal joint locking bolts from the
front axle and transmission end universal joints and
if necessary, remove the drive shaft.

14. Power steering piping

➀ Remove the clamps for power steering oil pipings.
➁ Disconnect the oil pipes and hoses and remove
them.

15. Wiring

➀ Disconnect the wire harness from the starter,
alternator, engine temperature switch, glow plug
and engine oil pressure switch, and move the
harness out of the way.
➁ Remove the starter mounting bolts and remove the
starter.
14
T017
T018
T019
T020