Boom Assembly - Oxy Heli OXY 3 Instruction Manual

Tail Servo Mount Assembly. (Box 02 / Bag 5)
Tail Servo Mount Position:
Install the Tail servo as shown, using the reference distance between the Tail Boom
End and Tail Servo Mount as shown. Lock all four Self Tapping Screws and add
CA super glue once the servo position is finalized. Don't install the Servo Arm in yet,
see page 29 for final Tail Servo Set-up.
Page 9
Chapter 6, Boom Assembly
Follow instruction for final assembly,
install WITHOUT over tightening
2 x TCEM2X6
M2x6 Hex Cap Screw
Don't fully tighten
yet, and dont apply
Loctite until the servo
position is finalized.
2 x DR0268
Frame C Washer M2
2 x TCEM2X5
M2x5 Hex Cap Screw
Don't fully tighten
yet, and dont apply
Loctite until the servo
position is finalized.
2 x OXY0084
Tail Servo Mount
Ref 63mm
Instruction Manual Rev 1