Mec JOE-100IM Instruction Manual

Mec JOE-100IM Instruction Manual

Waterproof lead-based battery charger for wet-, gel-, agm- and ca- batteries + power supply mode

Advertisement

Quick Links

Joe-100IM Battery Charger
Waterproof Lead-based battery charger
for Wet-, Gel-, AGM- and CA- batteries
12V 7A / 121-06702-530IM
Dear Customer!
Thank you very much for your trust in us and our product.
Please read these operating instructions carefully before start of operation.
MEC-Energietechnik GmbH

1. Safety Rules and General Warnings

Persons, which are not able to use the device in a safe way, because of their physical, sensory or mental competence, or
because of their inexperience, should not use the charger without control or instruction of a skilled person.
100-240 Volts alternating current, device is not suitable for children – Danger of life!!!
Avoid explosive gases, open flames and sparks – ensure for enough air ventilation while charging!
Explosion Risk!
The charger is exclusively designed for rechargeable Lead-based batteries and must not be used for other purposes.
Please consider the charging instructions from the battery manufacturer before charging!
Do not open! Repair work must only be accomplished by authorized companies or specialized technical staff.
If the mains connection of the device is damaged, it must be replaced with an original wire which is available at the manufac-
turer or costumer service.
Never place the device on top of the battery while charging!
Protect against direct solar radiation and temperatures over 40°C.
In case of obvious damage or malfunction disconnect the device from mains supply and protect against unintended reconnec-
tion.
The DC cable must not be cut or shortened.
phone: +43 (0) 4242 / 55 100 | fax: - 11 | e-mail: office@mec-energietechnik.at | Web: www.mec-energietechnik.com

-- Instruction manual --

+ Power supply mode

Version / MEC Art-No.
24V 4A / 121-12402-530IM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JOE-100IM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mec JOE-100IM

  • Page 1: Instruction Manual

    In case of obvious damage or malfunction disconnect the device from mains supply and protect against unintended reconnec- tion.  The DC cable must not be cut or shortened. phone: +43 (0) 4242 / 55 100 | fax: - 11 | e-mail: office@mec-energietechnik.at | Web: www.mec-energietechnik.com...
  • Page 2 MEC – Energietechnik GmbH INSTRUCTION MANUAL Joe-100IM 2. General Information This microprocessor based waterproof Lead Acid Battery Charger was especially developed for the outdoor use and for situations where water may be present. It can be used to charge any lead-based battery – including GEL, AGM, WET and CA. With the 5- step charging program the battery will be charged safely in a fully automatic mode.
  • Page 3 MEC – Energietechnik GmbH INSTRUCTION MANUAL Joe-100IM 5. Operation ATTENTION:  Before operating please make sure that the power cable and the charger including the charging cable show no damages and make sure that the mains supply complies with the specification.
  • Page 4 MEC-Energietechnik GmbH guarantees replacement or repair of chargers that are recognized as defective under common environmental conditions. The validation of the warranty time starts with the delivery date from the manufacturer. MEC- Energietechnik GmbH is limiting the free guaranteeing to working hours and spare parts only.

Table of Contents