Sleep Timer - Tecsun S-2000 Owner's Manual

3. While it's flashing, adjust the time that the radio is to play (1~90 minutes) with the TUNING
knob and press the TIMER A or B ON/OFF button with a long "B--"sound or simply let the
flashing number time-out to confirm it automatically.
After the alarm setting, it will auto start the alarm by radio
note that " " appears on the display.
Note:
You can also use the up or down ( /
hour and minute instead of the TUNING knob.
SELECT ALARM BY RADIO OR BY BUZZER
The TECSUN S-2000 has two alarm modes, alarm by radio
or by buzzer.
1. To activate the alarm by radio, press TIMER A or B ON/OFF
once with a "B" sound and notice that the "
up in the TIMER A or B display section.
2. To activate the alarm by buzzer, press again the TIMER A or B
ON/OFF with a "BB" sound and notice that the "
appears in the TIMER A or B display section.
3. Press again the TIMER A or B ON/OFF button with a long "B--"
sound and notice nothing appears in the TIMER A or B display
section to turn off the alarm.
Note:
1. Once the alarm is activated, no matter whether the radio is on or off, the alarm will force to
listen to the station that stored in TIMER A or TIMER B, or to make a sequential sound by the
buzzer, and turn off the radio in the time presetting in TIMER A or TIMER B.
2. In "Timer A" or "Timer B" section:
" " Means timer is set by radio
" " Means timer is set by buzzer.
" " Means Timer is off.
TO TURN OFF THE ALARM
Once the alarm is on by radio or buzzer, only the POWER, SLEEP, LIGHT/SNOOZE, and RESET
buttons can be operated. Press the POWER or SLEEP buttons to turn off the alarm.
www.tecsunradios.com.au
To activate the alarm by radio
) buttons to adjust the hour and minute or direct key in
To activate the alarm by radio
" symbol shows
To activate the alarm by buzzer
" symbol
15
STORING A STATION TO TIMER A OR TIMER B
- Turn on the radio and tune to a station that you want to store into
TIMER A or B.
- Long press TIMER A or B ON/OFF button with a "B" sound, note
that " " will flash in the top of the display and then stays in
section TIMER A or B.
Note:
If there is no station stored into TIMER A or TIMER B or the station being stored is out, noises
will be heard when the alarm is activated by radio.
SNOOZE
When the alarm is activated, press the SNOOZE button to
temporarily deactivate the timer for 10 minutes, notice that
" " or " " is blinking on the display before the alarm is
activated again. You allow to use 3 times of the SNOOZE
function within the alarm period, after that you can turn off
the alarm by press it again and " " or "

SLEEP TIMER

The sleep timer enables the TECSUN S-2000 to play any length of play time from 1-120 minutes
and then turn off automatically.
To turn on the sleep timer, press the SLEEP button under the
POWER button. Notice that the number of minutes to play
appears in the display, then you can either rotate the TUNING
knob or press / buttons or keep pressing the SLEEP
button to adjust your desired sleep timer. Press again the
SLEEP button or just leave it for about 3 seconds with a long
"B -- " sound to confirm your setting.
www.tecsunradios.com.au
flashing
flashing
flashing
" stays.
" " or " " is blinking on
the display when snooze is on.
16