Display Mode; Add Seconds To The Clock; Display Backlight; Setting The Sleep Timer - Tecsun PL-330 User Manual

Display Mode

When listening to the radio, quick press [ DISPLAY ] repeatedly to select
your preferred display mode. The top right corner of the display can show
signal strength/signal-to-noise ratio, clock time, alarm time, or the memory
location of the frequency (in VM mode only).

Add Seconds to the Clock

With the device turned off, press and hold [ 8 ] to add seconds to the clock.
Press and hold [ 8 ] again to hide the seconds from the clock.

Display Backlight

With the device turned on, press and hold [ 5 ] to select your preferred
backlight setting.
" ": Backlight is set to always-on.
" ": Backlight turns on when a button or tuning knob is used and turns
off after 5 seconds.

Setting the Sleep Timer

1) Turn the device off.
2) Press and hold the [ POWER ] button to enter the sleep timer setting.
3) Rotate the [ TUNING ] knob to select a power-off timer of 1-120 minutes,
or select "ON" to deactivate the sleep timer.
4) Quick press [
the display.

Activating/Deactivating the Alarm

Quick press [ ALARM ] to activate the alarm. The alarm "
shown on the display to indicate that the device will turn on at the preset
time. Quick press again to deactivate the alarm.
] to confirm. The sleep timer "
18
" icon is shown on
" icon is
www.tecsunradios.com.au