Lenovo ThinkCentre M800 User Manual page 71

Figure 21. Pivoting the drive bay assembly downward
16. Connect the signal cable and the power cable to the new 2.5-inch storage drive.
17. Install the optical drive. See "Replacing the optical drive" on page 55.
18. Install the front bezel. See "Replacing the front bezel" on page 54.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 86.
Replacing the 2.5-inch storage drive in the secondary storage drive bay
To replace the 2.5-inch storage drive in the secondary storage drive bay, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 54.
3. Remove the front bezel. See "Replacing the front bezel" on page 54.
4. Remove the optical drive. See "Replacing the optical drive" on page 55.
5. Locate the 2.5-inch storage drive you want to replace. See "Computer components" on page 5.
6. Disconnect the signal cable and the power cable from the 2.5-inch storage drive. See "Parts on the
system board" on page 6.
7. Press the retaining clip
same time.
1 in the direction as shown and pivot the drive bay assembly upward at the
.
Chapter 7 Installing or replacing hardware
61