Travis Industries 616 GSR Installation Instructions Manual page 8

13. Place the ember chunks as shown below. Note that half the bag of embers is left over.
14. Re‐apply the rock wool over the ember chunks along the front burner and between the two front logs for a natural look.
TIP: Applying rock wool in the cracks of the logs (see below) helps to add small points of glow, but may dampen the overall glow
of the logs.
TIP: Natural gas (NG) can use more rock wool than propane (LP).
NOTE: Initial application of rock wool may cause "matting" over burner ports. Turning the unit on and then off again will loosen
the rock wool, resulting in a better flame.
Page 8 of 10
616 GSR Traditional Log Set
Installation Instructions
17601679.docx — 6/14/13
(SKU 94500948)
© Travis Industries, Inc.