Ricoh Pro C550ex Network Manual page 58

1. Monitoring and Configuring the Machine
SMTPC: failed to connect smtp server.
1
SMTPC: username or password wasn't correct.
[response code] (information)
Snmp over IPv4 is ready
Snmp over IPv6 is ready.
Snmp over ipx is ready.
snmpd start.
started.
Started.
Terminated.
There is problem in dhcp server operation.
trap account is unavailable.
56
Message Problem and solutions
Connection to the SMTP server failed. This could be
because no connection to the network has been
established, or the network configuration is
incorrect, so there is no response from the SMTP
server, or the specified SMTP server name is
incorrect, or the specified SMTP server IP address
could not be found in the DNS server, or a server
other than the SMTP server has been specified, or
the specified SMTP server port number is incorrect.
Check the DNS Server's IP address and SMTP
server's IP address, or the SMTP server name and
SMTP port number, or the SMTP server's SMTP port
number, or the network connection and
configuration.
Connection to the SMTP server failed, because the
specified SMTP user name is incorrect, or the
specified SMTP password is incorrect. Check the
SMTP user name and password.
Communication over IPv4 with snmp is available.
Communication over IPv6 with snmp is available.
Communication over IPX with snmp is available.
The snmpd service has started.
The direct print service has started.
The bonjour (rendezvous) function is enabled.
The bonjour (rendezvous) function is disabled.
There is a problem with the DHCP server.
If multiple DHCP servers are active on the network,
check that they are assigning unique IP addresses
to each machine.
v3Trap cannot be sent. This could be because the
Trap destination account is different from the
account specified by the machine.