Ricoh Pro C550ex Network Manual page 56

1. Monitoring and Configuring the Machine
add_sess_IPX: bad trap <IPX address>
community <community name>
1
add_sess_ipx: community <community name>
already defined.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
Current Interface Speed: xxxMbps
Duplicate IP = <IP address> (from <MAC
address>).
inetd start.
Interface (interface name): Duplicate IP Address
(<IP address>).
< Interface > started with IP: < IP address >
no RADIUS/authentication server
server certificate invalid
server identity invalid
server not trusted
session IPv4 <community name> not defined.
54
Message Problem and solutions
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
whether or not the time system clock is set.
NTP Server: NTP server name
offset: number of seconds of delay (minus number
if a time in advance is specified)
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
The same IP address (IPv4, or IPv6 address) was
used. Each IP address (IPv4, or IPv6 address) must
be unique. Check the address of the device
indicated in [MAC address].
The inetd service has started.
The same IP (IPv4 or IPv6) address was used. Each
IP address must be unique. Check the address of
the device indicated in [IP address].
IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
The supplicant has received a message reporting
that a usable RADIUS server cannot be found.
The server ID is disabled. Check the server
authentication.
The server ID is disabled. Check the server
authentication.
The RADIUS server cannot be trusted.
The requested community name is not defined.