Altec Lansing M302 User Manual page 21

Symptom Possible Problem
iPod is not installed properly
iPod is locked up
iPod didn't charge
AC adapter isn't plugged into a wall outlet,
or the connector is not plugged into the
power supply jack on the back of the
speaker system
Volume level is set too high
Sound source is distorted
Sound is distorted
Battery is weak
Wireless remote doesn't work
Wireless remote is not pointed toward the
speaker system
No sound from the AUX Volume on the device is set too low
IN device, such as an
Source selector is not set to Aux Out
MP3 player or CD player
connected to the AUX IN jack
Solution
Remove your iPod from the dock and check for obstructions on the
connectors in the dock and on your iPod. Then reseat it in the dock.
Please make sure your iPod is working properly before docking into the unit.
Please refer to your iPod manual for details.
Plug the AC adapter into a wall outlet and plug the connector into the supply
jack on the speaker system.
Decrease the volume.
If the iPod original sound source (MP3) is of poor quality, distortion and noise
are easily noticed with high-power speakers. Try a different audio source such
as a music CD.
Replace current battery with a new battery.
Point the wireless remote toward the Altec Lansing speaker system and move
within 10 feet of the unit.
Increase the volume on the device to approximately ¾ full volume.
Set source selector to Aux Out.
Troubleshooting
19