Altec Lansing M302 User Manual page 18

Setting the Alarm
8
exit the Alarm Set mode.
Press the ALARM1 button on the speaker system or the ENTER
button on the wireless remote to exit the Alarm Set mode. The
speaker system will also automatically exit the Alarm Set mode after
5 seconds of inactivity.
NOTE When exiting the Alarm Set mode, the alarm is automatically turned
on. To turn off the alarm, press the corresponding ALARM1/ALARM2 button.
NOTE The alarm time is displayed in the lower right-hand corner of the LCD
display when you turn the alarm on. If both alarms are active, the time for
Alarm 1 will be displayed in the lower right-hand corner.
NOTE If both alarms are active at overlapping times, Alarm 1 takes
precedence over Alarm 2.
NOTE This Altec Lansing Moondance Home speaker system features
a built-in backup battery system to provide continuous clock settings in
the event of a power failure. If a power failure occurs or the AC cord is
accidentally disconnected, the display will not remain lit and the alarm will
not function, but the current time will be maintained.
NOTE If "iPod" is selected as the alarm source but no iPod is docked when
the alarm goes off, the buzzer alarm will sound instead.
If the iPod, FM radio or AUX IN is playing when the alarm goes off
NOTE
and a different alarm source has been selected, the speaker system will
switch to the selected alarm source.
How to Set Alarm 2
Repeat the above steps, substituting "Alarm 2" for "Alarm 1."
16
How to Use Alarm 1
1
Press the ALARM1 button on either the speaker system or the
wireless remote.
This activates the alarm. The Alarm 1 icon in the upper left-hand
corner of the LCD display will light and the alarm time will display in
the lower right-hand corner of the display.
2
When the clock times matches the alarm time, the alarm
sounds, the Alarm 1 icon flashes, and the whole display
flashes.
The alarm gets progressively louder until it reaches the set level. After
a total of 59 minutes, the alarm will silence itself.
3
To dismiss the alarm, press the ALARM1 or ALARM2 buttons
on the speaker system or the ALARM1 or ALARM2 buttons on
the wireless remote.
4
To disable the alarm before its time is up, press the ALARM1
button.
How to Use Alarm 2
Repeat the above steps, substituting "Alarm 2" for "Alarm 1."
How to Use the Snooze Feature
Press the SNOOZE button once to silence the alarm for a period of
9 minutes.