How To Program - Ad Notam REFLEXION Owner's Manual

HOW TO PROGRAM

It is possible to program every single key (except for the learn key itself) of the learnable WATERPROOF IR remote control.
STEP 1
Place the WATERPROOF IR remote control (learning) and
your external device remote control (teaching) head to
head, approximately 30cm apart, as shown below:
Teaching remote control
STEP 2
To enter the learn mode press and hold the learn key until
the LED indicator lights constantly. Please note: With no
action for more than 30 seconds the remote control will exit
learn mode automatically.
STEP 3
Press and release a key you wish to program on the
learnable WATERPROOF IR remote. The LED indicator will
still light constantly.
STEP 4
Press and release a key you want to capture on the teaching
remote. The LED indicator will start to blink slowly
indicating the IR command has been captured.
STEP 5
To save this IR code press and release the key you've just
choose to program on the learning remote. The LED
indicator will blink fast and then light constantly to indicate
this IR code has been saved.
STEP 6
To program more keys please repeat steps 3
learn mode.
STEP 7
To exit learn mode please press and release the learn key
again. The LED indicator will turn off.
IR command learning remote control
5 while in
RESET THE REMOTE
In order to reset all keys to ad notam factory default
IR commands please follow the next steps:
STEP 1
Press and hold the learn and power keys simultaneously
until the LED indicator lights constantly.
STEP 2
Enter the code 999 by Press and release the numeric 9 key
three times. The LED indicator will turn off and the remote
control has been reset to the initial IR codes.
30