Panasonic WJ-PR204 Operating Instructions Manual page 33

4-channel Receiver Side Unit connection example
In this example, the camera is powered by PoE and the receiver side unit is powered
by an AC adaptor.
D
A
A
D
A
D
A
D
Ethernet cable (Cat-5e or higher, straight)
Ethernet cable (Cat-5e or higher, straight)
Coaxial cable
Camera
Camera side unit
Receiver side unit
Switching hub
IMPORTANT
• A BY-HPE11KTA coaxial LAN converter cannot be connected.
• Use Cat-5e or higher Ethernet cables.
• Use 8-wire (4-pair) Ethernet cables.
• Use an Ethernet cable to connect the camera directly to the camera side unit.
Do not connect a hub between the camera and the camera side unit. When a
PoE or PoE+ camera is powered by an external power supply, use a PoE
incompatible cable (included with the camera side unit) to connect the camera
to the camera side unit.
• After disconnecting an Ethernet cable, wait at least 2 seconds before connecting
it again. If the cable is reconnected too quickly, power may not be supplied form
the PoE power supply.
• Some crossover-type Ethernet cables cannot supply power using PoE.
E
C
C
C
C
4 Connecting the Unit
G
B
F
Operating Instructions 33