Panasonic WJ-PR204 Operating Instructions Manual page 19

6. Screw tightening
• The screws and bolts must be tightened with an appropriate tightening torque
according to the material and strength of the installation area.
• Do not use an impact driver. Use of an impact driver may damage the screws or
cause tightening excessively.
• When a screw is tightened, make the screw at a right angle to the surface. After
tightening the screws or bolts, perform checks to ensure that the tightening is
sufficient enough so that there is no movement or looseness.
7. Coaxial cable connections
• Disconnect the coaxial cable from all devices and measure the insulation
resistance of the coaxial cable (new or existing) before making connections.
Insulation resistance value: 1 M or more for DC 500 V
• Confirm the length of the coaxial cable (see page 30, page 32).
• We recommend RG-6/U coaxial cable.
• The performance of the coaxial cable may be affected if it is relayed.
• Use only the following recommended BNC plug when connecting coaxial cables
to the BNC connectors of the unit.
– Applicable plug: MIL-C39012C, MIL-C39012/16F, or BS CECC2212: 1981
(Suffixes attached to the standards may be updated.)
– Tip dimensions inside the recommended BNC plug
IMPORTANT
• Use a suitable plug. Using a non-specified plug may cause a bad
connection or cause damage to the BNC connector.
BNC plug
(locally procured)
Coaxial cable
(locally procured)
Diameter: 1.32 mm (0.052 inches) to
1.37 mm (0.054 inches)
Diameter: 0.13 mm (0.005 inches) to
0.69 mm (0.027 inches)
1 Preface
Operating Instructions 19