3. Select the
Leaving time set
operating the
or
switch, and then
push the
switch.
4. The current setting will be displayed.
Push the
switch to enter the selection
mode.
by
5. Select the preferred setting by operat-
ing the
or
switch, and then push
the
switch.
6. Select Set by operating the
switch, and confirm the setting by pushing
the
switch.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and controls/Multi function display
7. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
3-91
CONTINUED