Subaru WRX STI Owner's Manual page 176

By operating the or switch on the
steering wheel, you can select the menu.
Pull the /SET switch to enter the
selected menu.
NOTE
If you enter the Return
system will return to the previous
screen.
Screen Settings
After entering the Screen Settings menu,
select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
On to activate the screens. Select Off
to deactivate the screens.
Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the ON
position can be activated or deactivated.
Select On to activate. Select Off to
deactivate.
Gear Position Indicator Setting
(MT models)
Display of the shift position indicator can
be activated or deactivated. Select On to
activate display of the shift position in-
dicator or Off to deactivate it.
Languages
Operate the
steering wheel to display the preferred
language. Then pull the
select the displayed language.
menu, the
REV settings (STI)
NOTE
If the setting of the REV Indicator Light
is Off , the setting menus of the REV
Alarm Level Engine Speed and the REV
Buzzer are not displayed.
After entering the REV settings menu,
select any of the following menus.
REV Indicator Light
Display of the REV indicator light can be
activated or deactivated. Select On to
activate display of the REV indicator light
or Off to deactivate it.
REV Alarm Level Engine Speed
The alarm-level engine speed can be set
(in 100 rpm steps) within the range from
2,000 rpm to the red zone.
REV Buzzer
The REV buzzer can be activated or
deactivated. Select On to activate the
REV buzzer or Off to deactivate it.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and controls/Multi information display
EyeSight (models with EyeSight
system)
NOTE
or switch on the
For models with the EyeSight system,
refer to the Owner s Manual supple-
/SET switch to
ment for the EyeSight system.
After entering the EyeSight menu, select
one of the following menus.
The volume of the warning buzzer that
sounds when the EyeSight system is in
use can be set in 3 stages ( Max , Mid
and Min ).
When adaptive cruise control is used, the
buzzer that sounds under any of the
following conditions can be activated or
deactivated.
. A vehicle is detected in front
. Detection is not possible
Select On to activate the buzzer. Select
Off to deactivate the buzzer.
When the lead vehicle moving monitor
function is operated, the buzzer that
sounds if a vehicle in front has started
can be activated or deactivated. Select
3-47
Warning Volume
Lead Vehicle Acquisition Sound
Lead Vehicle Moving Monitor
Function
CONTINUED