Horn; Removing And Installing Horn And Dual Tone Horn H1 - Audi 2003 A8 Workshop Manual

3

Horn

Observe notes on contact corrosion
3.1 Removing and installing horn and dual
tone horn - H1-
Removing
– Switch off ignition and take out ignition key.
Vehicles with twin grille:
– Unscrew bolts -arrows- at top of lock carrier and beneath Audi
rings.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Spray silicone-free lubricant all round into gap between radi‐
ator grille and bumper cover.
– First pull radiator grille -1- out of bumper cover by pulling it out
at locations marked with -arrows A-.
– Then pull bottom of radiator grille -arrows B- out of bumper
cover.
Vehicles with single-frame radiator grille:
– Remove bumper cover ⇒ Rep. gr. 63 .
All vehicles (continued):
– Unplug electrical connectors -1-.
– Unscrew nut -2- and detach horn or dual tone horn - H1- from
mounting.
⇒ page 264 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
105
3. Horn