Installing Remote Batteries - sky viper m200 Nano Drone Instruction Manual

INSTALLING REMOTE BATTERIES

Loosen screw in the Remote Control battery
compartment door with Philips screw driver and
insert batteries as shown. Replace door and
tighten screw.
WHEN NOT IN USE:
turn OFF the Remote Control and the
Always
Drone, when not in use or when being stored
or transported.
Store the Remote Control
area at room temperature.
Avoid temperatures less than 40°F/4°C and
greater than 120°F/49°C.
Do not leave the
a car or exposed to direct sunlight. If
exposed to temperatures greater than
120°F/49°C, the
batteries can be damaged or may catch
fire.
AUTO SHUTDOWN:
If battery voltage drops to an extremely low level, Drone will
automatically shutdown. The Nano Drone will need to be recharged to
restore flying power.
If anything prevents Drone's blades from spinning or they become
jammed, Drone will automatically shutdown. To restore flying power, turn
OFF the Drone and then turn it ON again.
3
3 x
1.5 V
+
–
AAA (LR03)
1.5 V
– +
AAA (LR03)
1.5 V
+ –
AAA (LR03)
and Drone in a dry
Remote Control or Drone in
Remote Control or Drone
+ AAA/LR03/R03 1.5V –
– AAA/LR03/R03 1.5V +
+ AAA/LR03/R03 1.5V –
OFF
OFF ON