Charging & Caring For Lipo Battery - sky viper m200 Nano Drone Instruction Manual

CHARGING & CARING FOR LIPO BATTERY
IN THE Drone
1
Turn OFF Remote Control & Drone.
2
Plug small end of the CHARGING CORD into the back of
the Drone.
3
Plug the large end of the CHARGING CORD into a
computer or USB power block.
RED LIGHT = CHARGING
GREEN LIGHT = FULLY CHARGED
4
Charge battery until full.
5
Once charged, unplug the large end of the CHARGING
CORD from the USB port.
6
Unplug small end of the CHARGING CORD from the back
of the Drone.
NOTE:
Always turn OFF the Drone when not in use.
CHARGING PRECAUTIONS:
After use, allow Drone (battery on bottom) to cool down to
room temperature before charging again.
Charge Drone in an isolated area, away from excessive
heat or moisture.
If you suspect that the battery is damaged or swelling,
turn off the drone immediately.
Do not modify, heat, or wet the battery in any way. Only
recharge with provided charger.
OFF ON
1
CHARGING
CORD
2
3
2