Installing Remote Batteries - sky viper V950STR Instruction Manual

WARNING!
IF AT ANY TIME DURING CHARGING OR USE THE BATTERY BECOMES DAMAGED IN ANY WAY,
DISCONTINUE CHARGING OR USE OF THE BATTERY IMMEDIATELY.
Continuing to charge or discharge a battery that has been damaged can result in a fire.
Quickly and safely disconnect the Drone from charging and place away from flammable
materials. Observe the battery for at least 30 minutes to be certain no additional swelling
or rupture occurs. Completely discharge the battery by submerging it in a saltwater
solution (1/2 cup salt per gallon of water) for 24 hours.
Check your local laws and regulations for correct recycling and/or battery disposal.
WHEN NOT IN USE:
Always UNPLUG the Drone's LiPo battery when not
in use or when Drone is being stored or transported.
Store the LiPo battery and Drone in a dry area at
room temperature.
Avoid temperatures less than 40°F/4°C and greater
than 120°F/49°C.
Do not leave the LiPo battery in a car or exposed to
direct sunlight. If exposed to temperatures greater
than 120°F/49°C, the LiPo battery can be damaged
or may catch fire.

INSTALLING REMOTE BATTERIES

Loosen screw in the Remote Control battery
compartment door with Philips screw driver and
insert batteries as shown. Replace door and
tighten screw.
AUTO SHUTDOWN:
If battery voltage drops to an extremely low level, Drone will automatically shutdown.
The Video Drone will need to be recharged to restore flying power.
If anything prevents Drone's blades from spinning or they become jammed, Drone will
automatically shutdown. The LiPo battery will need to be unplugged, then reconnected to
restore flying power.
3
1.5 V
+
AAA (LR03)
1.5 V
–
AAA (LR03)
4 x
1.5 V
+
AAA (LR03)
1.5 V
–
AAA (LR03)
–
+
–
+
LiPo BAT TERY
+ AAA/LR03/R03 1.5V –
– AAA/LR06/R03 1.5V +
+ AAA/LR03/R03 1.5V –
– AAA/LR03/R03 1.5V +