Charging, Installing & Caring - Lipo Battery - sky viper V950STR Instruction Manual

BLADE GUARDS FOR BEGINNERS
Blade guards are great for beginning pilots and can
be easily installed if desired. The guards however add
undesired weight and reduce flight performance.
Blade guards are optional and should NOT be used
with Advanced Flight Sensitivity setting 3.
1
Insert the posts of the blade guards into
the holes of the drone.
2
Secure the blade guards with the retaining screws.
CHARGING, INSTALLING & CARING FOR
LIPO BATTERY IN THE DRONE
1
Disconnect the LiPo battery connectors hanging out from the
back of the drone.
2
Plug the red male connector from the LiPo battery into the black
female connector end of the USB charging cord.
3
Plug the USB end of the charging cord into a USB power
source and charge battery until full.
RED LIGHT = CHARGING
GREEN LIGHT = FULLY CHARGED
4
Once fully charged, disconnect the charing cord from
battery and power source. (Always unplug from power
source when not in use).
IMPORTANT:
LiPo battery can be removed from Drone by loosening
battery compartment screw, opening door and removing
the battery. When replacing the battery, be careful not
to pinch battery connector wires when closing the door.
Also ensure that wires protrude through open slots on
the sides of the battery door as shown. Make sure there
is sufficient wire slack for easily connecting and
disconnecting plugs, but not so much slack that wires
interfere with spinning blades.
CHARGING PRECAUTIONS:
After use, allow LiPo battery to cool down to room temperature before charging again.
Charge LiPo battery in an isolated area, away from excessive heat or moisture.
If LiPo battery swells, unplug it immediately and permanently discontinue use.
Do not modify, heat, or wet the battery in any way. Only recharge with provided charger.
1
1
2
2
2