Setting The Depth Incremental Alarm ("Increm"); Setting The Dive Time Interval Alarm ("Diveint"); Setting The Surface Interval Alarm ("Surfint") - Uwatec M2 User Manual

By pressing the SEL button in this menu
the on/off selection starts blinking. This can
be edited by pressing the +/UP or -/DOWN
buttons and then confirmed by pressing
the SEL button. After that the first depth
starts blinking. By pressing the +/UP or
-/DOWN buttons you may select the first
depth alarm from 5 to 100m (20..330ft). By
pressing SEL the first value is confirmed
and the second depth starts blinking. Like
the first, by pressing the +/UP or -/DOWN
buttons the second depth alarm may be
set from 5 to 100m.
F
NOTE: The first alarm is short
sequence to get your attention, while
the second alarm is continuous. By
setting the first alarm deeper than
the second, it will be masked by the
continuous alarm and you may not be
able to hear it.
4.4.4 Setting the depth incremental
alarm ("INCREM")
By pressing the SEL button in this menu
the incremental mode starts blinking. By
pressing the +/UP or -/DOWN buttons you
may scroll through the alarm's values or
disable it with the following selections: off,
dn(down), up, or both. After confirming the
selection with the SEL button, the depth
alarm starts blinking. By pressing the +/
UP or -/DOWN buttons you may select the
alarm value from 5 to 100m (20..330ft). By
pressing the SEL button the alarm value will
be confirmed.
M2 USER MANUAL
4.4.5 Setting the dive time interval
alarm ("DIVEINT")
By pressing the SEL button in this menu the
function starts blinking and you may enable
or disable it by choosing on/off with the +/
UP or -/DOWN buttons. After confirming
your selection by pressing the SEL button,
the time starts blinking. By pressing +/UP
or -/DOWN you can select the interval from
15 seconds up to 10 minutes. By pressing
SEL again the selection will be confirmed.
4.4.6 Setting the surface interval
alarm ("SURFINT")
By pressing the SEL button in this menu
the function starts blinking and you may
enable or disable the alarm by selecting on/
off with the +/UP or -/DOWN buttons. After
confirming your selection by pressing the
SEL button, the surface interval time starts
blinking. By pressing +/UP or -/DOWN you
can select the interval from 15 seconds up
to 10 minutes. By pressing SEL again the
selection will be confirmed.
35