The M2 As A Dive Computer; Settings In The Dive Mode At Surface ("Dive") - Uwatec M2 User Manual

The logbook presents the start time and
date on the main page. By pressing the
SEL button you can review (see the display
below) the amount of repetitive movements
(4887), exercise time (35 minutes 44
seconds) and total elevation done during
the exercise (200m).
Additional information can be reviewed
when the log is read from LogTRAK.
24
4. THE M2 AS A DIVE
COMPUTER
The M2 is a full-featured diving computer,
capable of multi gas nitrox decompression
calculations, CCR mode, ascent rate
calculations and warnings. The logbook
can store up to 50 hours of dive profiles
with a 4s sampling rate. During the dive
the M2 displays information such as depth,
dive time, decompression status, water
temperature and much more. On the
surface after a dive, remaining desaturation
time, NO-FLY time, surface interval and
prohibited altitude classes are shown in
addition to the watch functions.
4.1 Settings in the dive mode
at surface ("DIVE")
When the M2 is in Surface mode, you can
access various menus dedicated to diving and
customize various settings to your liking.
The dive computer functions of the M2 on the
surface include, among others, setting the
oxygen concentration for nitrox diving, setting
the MB level of the decompression algorithm,
and setting various warnings and personal
preferences. To reach any of these functions,
the M2 must be in the Dive surface mode
display. This can be reached by pressing the
+/UP or -/DOWN button until the indicator
arrows are pointing to Dive, and then select
this mode by pressing SEL.
M2 USER MANUAL