Special Mode; Special Mode Setting Button ( For E300 Model) - Denon AVR-E300 Service Manual

SPECIAL MODE

Special mode setting button ( for E300 model)

b No.1 - 9 : Press the
b No.10 : Turn on the power, then press and hold down A and B buttons for over 3 second.
No. Mode
Version display
1
(μcom/DSP Error Display)
Errors checking
2 (Displaying the protection history
mode)
User Initialization
3 (Installer Setup settings are not
initialized.)
Factory initialization
4 (Installer Setup settings are
also initialized)
Mode for preventing remote
5
control acceptance
6 Panel lock
Panel lock
7
(Master volume is not locked.)
8 Cancellation of panel lock
9 Diagnostic
10 Remote ID Setup
X
SOURCE SELECT 0
X
button to turn on the power while pressing both the button A,B and the button C at the same time.
Button A Button B
DIMMER STATUS
TUNER
DIMMER
PRESET CH +
SOURCE SOURCE
SELECT 0 SELECT 1
TUNER
DIMMER
PRESET CH +
TUNER
SOURCE
PRESET CH +
SELECT 1
↑ ↑
↑ ↑
↑ ↑
TUNER
DIMMER
PRESET CH +
DIMMER STATUS
SOURCE SELECT 1 TUNER PRESET CH +
Button C
Firmware versions such as Main or DSP are displayed in the
- FL manager. Errors are displayed when they occur.
(Refer to
The protection history is displayed.
STATUS
(Refer to
Backup data initialization is carried out.
-
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
-
(Installer Setup settings are also initialized)
Operations using the remote control are rejected.
Press the SOURCE SELECT 0 / 1 to select "RC LOCK On",
- then press the "STATUS" button to set.
(Mode cancellation: Execute the same button operations as
when performing setup and select "RC LOCK Off".)
Operations using the main unit panel buttons or the master
volume knob are rejected.
-
Press the SOURCE SELECT 0 / 1 to select "FP/VOL LOCK
On", then press the "STATUS" button to set.
Operations using the main unit panel buttons are rejected.
- Press the SOURCE SELECT 0 / 1 to select "FP LOCK On",
then press the "STATUS" button to set.
Panel lock mode is cancelled.
(Mode cancellation: Execute the same button operations as
-
when performing setup and select "FP LOCK Off", then press
the "STATUS" button to set.)
This mode is used for confirming the Video and Audio signal
paths. (Troubleshooting)
STATUS The signal paths of the set can be easily confirmed after
repair.
(Refer to
When using multiple DENON AV receivers in the same
- room, make this setting so that only the desired AV receiver
operates.(Refer to
DIMMER STATUS
17
Contents
20 page)
23 page)
29 page)
25 page)