Belt Clip; Headset - AT&T 2462 User Manual

2462_00_1 ATT CIB 1/28
INSTALLATION
3 Charge the handset battery.
• Place the handset in the remote charging stand. The
CHARGING light goes on.
• Charge the battery for at least 12 hours. After the first charge,
the battery typically charges in only eight hours.
4 Check for dial tone.
• After the batteries are charged, lift the handset and press
L; you should hear a dial tone.

Belt Clip

Attach belt clip to the cordless handset (optional).
a) Slide down into
grooves to attach.

Headset

You can use this telephone with any industry
standard 2.5 mm headset (purchased separately).
For best results, use an AT&T 2.5 mm headset.
Plug the headset into the jack located on the
left side of the handset (under the small
rubber flap) or into
the jack on the right
side of the base
Do not force the
connection, but
make sure the
plug fits securely.
6
1/28/02 9:52 AM Page 6
b) To remove, lift one side
with your thumbnail
and push back.
Headset jack