Installation - Motorola MTH800 Installation Manual

Table 1: FTN6790B Specifications
Input Voltage
Range
Output Voltage
Max. Output
Current
Dimensions
(regulator unit
block)
Input cable
Output cable

Installation

1. The positive supply to the regulator should be taken from an
ignition switched source. This can be connected to the same
supply as used for ignition sense to DCK control box (green wire).
The positive supply must be fused at maximum 1 A rating.
2. Connect coaxial cable end to 5 V input terminal on diplexor unit.
3. Run supply cable to selected connection point, ensuring that it is
secured from being damaged and does not interfere with any
vehicle controls or airbag deployment.
4. Connect grey regulator positive feed wire to ignition sense feed,
via 1 A fuse (using holder and connectors supplied).
2
Specification
7–30 V
5 V
40 mA
41 x 12.5 x 12.7 mm
Twin Figure-8
Length: 560 mm
Negative marked black
tracer line
RG174 Coaxial Cable
Length: 550 mm
Terminated FME Jack (f)
Centre contact positive
supply
Kit Content
Regulator unit
moulded with
input and output
cables
1 x Fuseholder
1 x Fuse 1A rated
2 x Blade
connectors - red
insulated