Erasing Cd Titles; Time Edit; Direct Track Access - RCA RP8085 Manual

Using the CD Player

Erasing CD Titles

EN
For single disc:
1. Press CD TITLE to activate the feature. "CD
TITLE" will flash on display.
2. Press OK to confirm the activation.
3. The CD title is shown on display. Press
CLEAR to erase the title.
4. Press CD TITLE to confirm the erasure of
title.
For all discs:
All disc titles erasure is possible in unit Standby
mode only.
1. Press and hold CLEAR. While you are still
pressing CLEAR, press and hold PROG on
the panel for a while and then release both
keys at the same time.
2. The display will show "DEL MEM?", then
press OK to confirm deletion.
3. "DELETE..." is shown on display. The
deletion will be completed in a few
seconds.
Tip: This unit can store up to 128 disc titles. When
the memory is full, "MEM FULL

Time Edit

After inputting the length of your cassette
tape, this feature can program automatically
the disc tracks in the order best for your
recording.
1. Press TIME EDIT on the remote control.
2. Press again repeatedly to select among the
following cassette length:
a. C46 23:00 (lenght on a side in minutes)
b. C54 27:00
c. C60 30:00
d. C74 37:00
e. C90 45:00
f. C100 50:00
g. C120 60:00
3. Press OK to confirm the length. The unit
will enter program mode and program the
tracks automatically to best fit the time
length on a cassette tape side. When
programming completes, playback program
will be shown on display.
4. While display is still showing the playback
program, press PAUSE to enable free
10
MEM FULL MEM FULL" will show on display. MEM FULL MEM FULL
programming by yourself to be recorded on
side B of the cassette tape. (Note: when
playback ends for recording on side A of
cassette tape, the unit will pause playback
automatically. You can then change side of
the cassette tape and start playback again
for recording).
5. Press OK to confirm program.
Tips: you can also activate time edit function in
program mode under the following conditions:
1. The total programmed track time is known.
2. Program inputting mode is still active.
3. The selected cassette length should be longer than
the total time of the current program.

Direct Track Access

Access the track by directly inputting the track
numbers. For examples, for track 3, press 3,
for track 13, press 1, and within 3 seconds,
press 3 to access track 13. Otherwise, track 1
will be selected for failing to input the second
digit within 3 seconds.
Remarks:
1. The player will go to normal playback mode or
repeat mode after activating direct track access.
2. If you directly access a track which is not selected
in CD title program, this track will be stored in the
program automatically.