Rechargeable ultra-high variable-output led flashlight (30 pages)
Summary of Contents for Surefire Powerselect 9AN Commander
Page 1
POWERSELECT COMMANDER 20/140 Lumens Congratulations, with the purchase of this SUREFIRE flashlight, you have invested in one of the world’s best “illumination tools.” We believe it to be a prime example of our philosophy that design decisions should always be made in the interest of the product being the very best it can be.
Page 3
THE 9AN COMMANDER The 9AN Commander Rechargeable Flash- light is a masterpiece of engineering. This is a one-of-a-kind, high performance unit that does the job of two flashlights. Sim- ply rotate the 9AN head to choose one of two power settings; one projects a low, soft 20 lumen light for close-up activities such as report writing, and the other level gives you a brilliant, high-power 140 lumen beam with...
Page 4
9AN COMMANDER There are two ways to activate the light from the 9AN. The Tail Cap switch of the Flash- light can be activated by rotating the Tail Cap in a clockwise direction for a constant “ON” setting or by pressing on the Push Button for temporary light.
SPECIFICATIONS Power Output 20/140 Lumens - N90 Run Time 20 lumens - 120 Minutes 140 lumens - 40 Minutes Battery Type Ni-Cd Number Required One (1) Supplied Length 7.9 inches Weight 12.9 ounces Diameter Body - 1.28 inch Bezel -1.63 inch Lamp Assembly Xenon Lens...
PARTS REPLACEMENT LIST Component Part No. Battery - Nc-Cd Bezel Assembly 13270 Flashlight Body 14108 Lamp Assy Lens 11956-1 O-Ring Seal (rear) 19-01-040 O-Ring Seal (front) 19-01-023 Lock Out Tail Cap Assy 12708 WARNING The Reflector Body is vented for use with Ni-Cd batteries.
Avoid touching the inside of the Lamp en- velope as this will degrade the performance of your SUREFIRE Light. 4. Secure the Lamp Assembly to the Bezel by installing the Nylon Screw. 5. Install the Bezel back on to the Body.
Page 9
INSTALLING THE BATTERY 1. Remove the Flashlight Tail Cap by un- screwing it until it is free of the Flashlight Body. 2. Insert the B90 Ni-Cd Battery, observing proper battery polarity, into the Flashlight Body. 3. Install the Flashlight Tail Cap back on to the Flashlight Body by turning it until the light comes on.
SELECTING POWER LEVEL The 9AN Commander has two seperate lamp assemblies within the bezel reflector. When operating on the general use beam of 20 lu- mens only one lamp assembly is activated. For the high power 140 lumen beam both lamp assemblies are activated For 140 Lumen Beam While holding the Head of the 9AN, turn the...