Operation; Before Startup; Dry Vacuum Cleaning - Kärcher WD 3 Premium Operating Instructions Manual

Removable handle
Illustration
 Connect the handle with the suction
hose until it snaps in place.
Illustration
 To remove the handle from the suction
hose, press the notch using your thumb
and pull off the handle.
Note: Due to removing the handle, acces-
sories can be directly attached to the suc-
tion hose.
Recommendation: In order to vacuum the
floor, attach the handle to the suction hose.
See position 12.
Suction tubes 2 x 0.5 m
Illustration
 Put both suction tubes together and
connect them with the handle.
Crevice nozzle
 For edges, joints, heaters and hard to
reach locations.
Floor nozzle
(with inserts)
Illustration
 When vacuuming dry dirt off the floor,
clip an insert with two brush strips into
the floor nozzle.
 When vacuuming water off the floor,
clip an insert with two rubber lips into
the floor nozzle.
8
CAUTION
Always work with an inserted cartridge filter
during wet as well as dry vacuum cleaning!

Before Startup

Illustration
 Mount loose parts delivered with appli-
ance prior to start-up.
Illustration
 Connect accessories.
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.

Dry vacuum cleaning

CAUTION
Check the filter for damage prior to installa-
tion and replace as necessary.
Work with a dry cartridge filter only!
Illustration
 Recommendation: To vacuum fine
dust, use the filter bag.
Information filter bag
The filling level of the filter bag depends
–
on the dirt that is sucked in.
The filter bag needs to be replaced
–
more frequently while sucking in fine
dust, sand, etc.
Clogged filter bags can burst - therefore
–
make sure to replace the filter bag in a
timely manner!
CAUTION
Vacuum cold ashes only when using a pre-
filter.
Order no. basic design: 2.863-139.0, pre-
mium design: 2.863-161.0.
– 8
EN

Operation

Start up