Table of Contents
Advertisement
Fuses
The MAC 2000 Wash is supplied with:
• two 20 AT (time delay) main fuses for use with AC supplies of 100 - 130 volts.
• two 15 A main fuses for use with AC supplies of 200 - 250 volts.
Install the appropriate fuses in the holders near the power switch.
Power connection
Important! Connect the MAC 2000 Wash directly to AC power. Do not connect it to a dimmer system;
doing so may damage the fixture.
You may need to install a cord cap that fits your supply on the power cable. A 3-prong grounding-type plug
must be installed following the manufacturer's instructions. The table shows some possible pin identification
schemes; if the pins are not clearly identified, or if you have any doubts about proper installation, consult a
qualified electrician.
To apply power, set the power switch on the base to the "I" position.
Wire Color
brown
blue
yellow/green
Reduced power function
The MAC 2000 Wash has an automatic power reduction function, which reduces the consumption to 700W
if the shutter/dimmer is closed for more than 10 seconds. This not only increases the lamp life, but also
further decreases the overall noise emission of the fixture.
Pin
Symbol
live
L
neutral
N
ground
Table 1: Cord cap connections
AC power
Screw (US)
yellow or brass
silver
green
9
Advertisement
Table of Contents
