Introduction; Mac 2000 Wash Safety Information - Martin Professional MAC 2000 Wash User Manual

I
NTRODUCTION
Thank you for selecting the MAC 2000 Wash. The MAC 2000 Wash is a 1200 Watt moving head wash light
that provides CMY color mixing, color correction (CTC), two color wheels (each with four removable colors),
a combined dimmer/shutter. 540° of pan and 267° of tilt. A motorized barn-door system and optional
dimmer wheel are available as a separately orderable accessory.
The MAC 2000 Wash has a Fresnel lens fitted as standard, and is also supplied with a PC lens and a
super-wide-angle lens. A motorized zoom provides beam angle ranges of 11° through to 40° (in the
standard Fresnel configuration), 12° through to 34° (with the PC lens fitted), or 66° through to 80° (with the
super-wide-angle lens fitted).
The MAC 2000 Wash is fitted with an electronic ballast that provides flicker-free operation and an
economical power-saving mode. The power supply unit is switchable to match 100 - 130 V or 200 - 250 V
local power supplies.
Note: This manual describes functionality available from version 1.7 of the MAC 2000 Wash
firmware. For the latest firmware updates, documentation, and other information about
this and all Martin Professional products, please visit the Martin web site at
http://www.martin.com.

MAC 2000 Wash safety information

Warning! This product is for professional use only. It is not for household use.
This product presents risks of lethal or severe injury due to fire and heat, electric shock, ultraviolet radiation,
lamp explosion, and falls. Read this manual before powering or installing the fixture, follow the safety
precautions listed below and observe all warnings in this manual and printed on the fixture. If you have
questions about how to operate the fixture safely, please contact your Martin dealer or call the Martin
24-hour service hot line at +45 70 200 201.
Protection from electric shock
• Disconnect the fixture from AC power before removing or installing the lamp, fuses, or any part, and when
not in use.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both overload
and ground-fault protection.
• Do not expose the fixture to rain or moisture.
• Refer any service operation not described in this manual to a qualified technician.
Protection from UV radiation and lamp explosion
• Never operate the fixture with missing or damaged lenses and/or covers.
• When replacing the lamp, allow the fixture to cool for at least 15 minutes before opening the fixture or
removing the lamp. Protect your hands and eyes with gloves and safety glasses.
• Do not stare directly into the light. Never look at an exposed lamp while it is lit.
• Replace the lamp if it becomes defective or worn out, or before usage exceeds the maximum service life.
Protection from burns and fire
• Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones of the
specified type and rating.
• Keep all combustible materials (for example fabric, wood, paper) at least 1 meter (39 inches) away from the
fixture. Keep flammable materials well away from the fixture.
• Do not illuminate surfaces within 3 meters (10 feet) of the fixture.
• Provide a minimum clearance of 0.1 meters (4 inches) around fans and air vents.
• Never place filters or other materials over the lens.
4 MAC 2000 Wash