Cleaning Debris From Shielding Gas Filter Fitting - Miller Electric SuitCase X-TREME 12VS Owner's Manual

7-3. Cleaning Debris From Shielding Gas Filter Fitting

Tools Needed:
3/4 in.
OM-252 203 Page 26
Rear View of Feeder
!
Disconnect power
maintaining.
1 Shielding Gas Filter Fitting
Remove fitting from gas valve on
back panel of feeder.
Blow compressed air through the
threaded male end of fitting to dis-
lodge debris from internal mesh
screen.
.
if blowing compressed air
through fitting does not clear
obstructions replace fitting.
Reinstall fitting into gas valve.
Tighten fitting to 250 in. lbs (28 N⋅m).
1
before
256 623-A