Chapter 1 Introduction; Mobile Radio Description; Overview; Dimensions - Vertex Standard VXD series Installation Manual

Chapter 1 Introduction

This manual covers the installation procedures for VXD Series Mobile Radios and accessories re-
quired to complete the radio system. The radio system consists of a control head, radio, antenna, mi-
crophone, speaker, cabling, and accessories.

1.1 Mobile Radio Description

1.1.1 Overview

VXD-7200: The Display model with 4 programmable buttons and a dot-matrix LCD.

1.1.2 Dimensions

Figure 1-1 and Figure 1-2 show the basic dimensions of the dash mount trunnion of the mobile radio.
When installing the radio, make sure to plan the installation carefully and leave additional room in the
rear of the radio for cabling and accessory connections; in the front of the radio for access, controls,
and cabling; and to the sides of the radio so that you may access and install the trunnion wing screws.
2.4"
Figure 1-2 Side View of Dash Mount with Low Profile Trunnion
NOTE: The rear accessory connector adds 0.75 in. (1.91 cm) to the overall length.
8.2"
6.8"
Figure 1-1 Front View of Dash Mount Trunnion
2"
Chapter 1 Introduction
8.3"
7.9"
Page 7