Casio MZ-X300 User Manual page 58

■ MIXER Screen
This screen mixer lets you adjust the source tone, volume level, and other setting items of the Digital Keyboard
sound source parts (Parts 01 through 16), while viewing the balance between the parts on the display. For details,
see "Using the Sliders" (page EN-24).
Level meter
Item
Part
Tone
Solo
Volume
Pan
Coarse Tune
Fine Tune
Bend Range
Reverb Send
Chorus Send
Delay Send
Line Select
Port
Level/Param switch
Level meter
• Besides part 01 through 16, the MIXER screen can be used to change External (external parts) and Mix (all parts)
settings. Note, however, that External and Mix can be used to change only the parameters below.
External: Volume, Reverb Send, Chorus Send, Delay Send, Line Select
Mix: Volume
• When "Solo" is turned on, pressing a keyboard key sounds that part only. All other types of performance
operations (layer, split, Auto Accompaniment, etc.) are disabled.
A part that is turned on is sounded. Turn off parts you do not want to sound. Off, On
Changes the tone.
Turn on to sound the applicable part only.
Adjusts the volume. The volume level of each part is shown by an on-screen
level meter.
Specifies the stereo pan position of the sound output by the Digital
Keyboard. 0 indicates the center, while a smaller values shifts to the left and
a larger value shifts to the right.
Specifies, in semitone steps, the pitch of the notes of each part.
Specifies, in cent steps, the pitch of the notes of each part.
Adjusts, in semitone steps, the bend range of each part.
Specifies how much reverb is applied to each part.
No reverb is applied at all when this setting is 0, while maximum reverb is
applied when it is 127.
Specifies how much chorus is applied to each part.
No chorus is applied at all when this setting is 0, while maximum chorus is
applied when it is 127.
Specifies how much delay is applied to each part.
No delay is applied at all when this setting is 0, while maximum delay is
applied when it is 127.
Specifies which DSP is applied to the selected part.
Specifies the port. For information about MIDI channels assigned to each
port, see "Part and MIDI Channel Assignments and Diagram" in the
separate "Tutorial" manual.
Toggles the level meter display between volume levels and parameter
settings.
Shows the volume level or setting of each part.
Configuring Digital Keyboard Settings
Meaning Setting
1100 (MZ-X500),
900 (MZ-X300)
Off, On
0 to 127
–64 to 0 to +63
–24 to 0 to +24
–99 to 0 to +99
0 to 24
0 to 127
0 to 127
0 to 127
Off, DSP1, DSP2
Port A, Port B,
Port C
Param, Level
–
EN-57