Installation And Adjustment; Tools; Manner Of Delivery; Mounting / Removing Rear Frame - Vermeiren Venus 3 Instruction Manual

3

Installation and adjustment

The instructions in this chapter are for the user and the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility. A list of
Vermeiren facilities can be found on the last page.
L
WARNING: Risk of unsafe settings - Use only the settings described in this manual.
L
WARNING: Risk of tipping over - Variation allowed adjustments can still change the
stability of your scooter (tilt back or sideways).
3.1

Tools

To set up the scooter the following tools are needed:

Screwdriver

Wrench set n° 10

Allen keyset n° 6
3.2

Manner of delivery

The scooter shall be delivered with:

Frame with armrests, steering column, rear and front wheels, anti-tipping wheels

Footplate

Seat + backrest

Batteries, motor (2x)

Shopping basket

Accessories

Manual
3.3

Mounting / removing rear frame

L
WARNING: Risk of injury - Be carefull that you do not pinch your fingers, hands between
the frame.
L
CAUTION: Risk of injury - Check that the front and rear frame is fixated properly.
Removing rear frame:
1. Pull the locking plate
2. Move the front frame a little bit
backwards by holding the locking
.
plate
3. Slide the front frame out the rear
frame by holding the locking plate
Mounting rear frame:
1. Grasp the locking plate located
the front frame.
2. On the front frame and rear frame are
red lines (marks) check that these are
on the same location (tubes of the
front frame must be mounted in the
hooks of the rear frame).
3. Slide the front frame in the rear frame
by holding the locking plate
4. Push the locking plate
until the two frames clicks in each
other.
5. Check that the frames are mounted
very well in each other.
Page 20
Venus 3, Venus 4
2014-03

upwards.
.

on
.

downwards