Sirius Satellite Radio Dock & Play PowerConnect User Manual page 35

Second vehicle kit

Hide thumbs Also See for Dock & Play PowerConnect:

Table of Contents

and above the doors . Airbag locations are marked with "SRS"

logos . Be careful not to crimp or cut the cable .

4 . Bring the cable out from the trim near the front of the cabin

and route it under the carpet toward the dashboard or console .

Coil any excess cable in a hidden location, such as under the

carpet, keeping it away from any vehicle pedals or controls .

Secure the excess cable with wire ties (purchased separately) .

5 . Bring the end of the cable out at the

Dock location . Leave yourself enough cable so you can easily

connect it to the antenna connector of the dock .

6 . Continue with "Step 5: Connect the Magnetic Mount Antenna

and PowerConnect Power Adapter" on page 37 .

• Pickup Truck:

1 . Use a blunt plastic putty knife or similar blunt tool to lift the

rubber molding around the windshield and tuck the antenna

cable underneath it .

2 . Continue tucking the cable underneath the windshield molding

around the windshield to the lowest corner .

3 . At the lowest corner of the windshield, route the cable out of

the windshield molding and into the rubber weather stripping

around the door opening . Lift the weather stripping from the

opening and tuck the cable inside it, then replace the weather

stripping . Run the cable inside of the weather stripping to the

bottom of the door opening .

4 . Pull the cable out of the weather stripping at the bottom of the

PowerConnect Vehicle

Table of Contents