Cleaning Foreign Object Trap; Preventative Maintenance - Speed Queen AFNE9RSP113WH User Manual

Maintenance
1. Shipping Brace
Figure 2
1. Shipping Bolt Assembly
Figure 3
Refer to the Installation instructions for proper procedures when-
ever the washer is moved.

Cleaning Foreign Object Trap

The washer's pump has a trap that may collect foreign objects. The
trap may need to be cleaned if water is draining slower than usual.
To clean:
1. Disconnect washer from electrical supply.
2. Remove two screws at bottom of the front access panel.
3. Rotate bottom of panel out and remove panel.
NOTE: The pump may have some water in it. Use a
rag or a container to catch water. If the wash drum is
full of water, use a wet/dry shop vacuum to catch the
water.
4. With rag or vacuum ready, unscrew the cap on the left side of
the pump and remove trap.
5. Clean the debris from the trap.
6. Reinstall the trap and access panel.
7. Reconnect washer to electrical supply.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
FLW2296N_SVG
1
FLW2297N_SVG

Preventative Maintenance

Follow these guidelines to ensure the washer operates properly.
Call for service if you observe any of the following: water of any
amount on the floor, an increase in operating noise or water re-
maining in the wash basket after a cycle.
Frequency
Monthly
Every six months
Every five years
24
Maintenance Procedure
1. Check all hoses and the
drain for leaks.
2. Check the door lock for
proper operation.
3. Clean the dispenser drawer.
Refer to Using Your Dis-
penser Drawer.
4. Check to make sure the
washer is level.
1. Clean the filter screens in
the fill hoses.
2. Clean the door gasket with
a bleach and water solution.
1. Have a qualified service
technician conduct general
preventative maintenance
on the washer to ensure it
operates properly.
2. Replace the fill hoses.
Part No. 804648R4