Speed Queen AFNE9RSP113WH User Manual page 27

Washer Symptom
Load is Too Wet
Wrong Water Temperature
Control not responding to keypad selections
Er, do on digital display
Er, dL on digital display
Er, dr on digital display
Er, FL on digital display
Er, nF on digital display
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Possible/Cause Solution
• Wash load may be unbalanced. The washer may have limited the
spin speed to prevent damage to the machine. Redistribute the
load and run a Spin cycle.
• Load is too small. Add items to make full load.
• Make sure that the controls are properly set.
• Check fill hoses. Make sure hot faucet hose is connected to hot
mixing valve (indicated with "H" on the valve bracket) and cold
faucet is connected to cold mixing valve (indicated with "C" on
the valve bracket).
• Make sure laundry room water heater is adjusted properly.
• The Normal Eco cycle uses a colder water temperature.
• Make sure Control Lock feature is off. If on, Control Lock light
will be lit.
• Press and hold Signal Keypad for three seconds to turn off.
• The control senses that the door is open during a running cycle.
• Unplug the machine to clear this code.
• The control senses that the door has unlocked during a running
cycle.
• Unplug the machine to clear this code.
• This code indicates that water is still in the washer at the end
of the cycle.
• Check the drain hose and drain receptacle to make sure they
are installed properly and not blocked.
• Foreign object trap in pump may be clogged. Clean the trap. Re-
fer to Maintenance section.
• Unplug the machine for 15 seconds to clear this code.
• This code will appear if the washer has not reached the fill level
after 30 minutes during a wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5
minutes of the current fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter
screens located at the faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
27
Troubleshooting
Table continues...
Part No. 804648R4