Lane Change Assist; High/Low Beam Switch; Flash-To-Pass; Front Map/Reading Lights - Jeep Cherokee 2015 Owner's Manual

Hide thumbs Also See for Cherokee 2015:

Table of Contents

166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

• If either light remains on and does not flash, or there is

a very fast flash rate, check for a defective outside light

bulb. If an indicator fails to light when the lever is

moved, it would suggest that the indicator bulb is

• A "Turn Signal On" message will appear in the EVIC/

DID and a continuous chime will sound if the vehicle

is driven more than 1 mile (1.6 km) with either turn

• When the Daytime Running Lights are on and a turn

signal is activated, the Daytime Running Lamp will

turn off on the side of the vehicle in which the turn

signal is flashing. The Daytime Running Lamp will

turn back on when the turn signal is turned off.

Lane Change Assist

Tap the lever up or down once, without moving beyond

the detent, and the turn signal (right or left) will flash

three times then automatically turn off.

Push the multifunction lever away from you to switch

the headlights to high beam. Pull the multifunction lever

toward you to switch the headlights back to low beam.

You can signal another vehicle with your headlights by

lightly pulling the multifunction lever toward you. This

will turn on the high beams headlights until the lever is

The front map/reading lights are mounted in the over-

head console. Each light can be turned on by pushing a

Table of Contents