Reset - TP-Link TL-WPA4220 User Manual

Step 1. Press and hold the Pair button on powerline device C TL-WPA4220 for one second.
Step 2. Within two minutes, press and hold the Pair button on Powerline device A/B for one second.
Step 3. Wait for about 60 seconds while your powerline devices are connecting. The Power LED on
powerline device A/B and C will stop flashing and become solid on when the connection is
made.

Note:
The sequence of Step 1 and Step 2 can be exchanged.
Leave an existing Powerline Network:
As the figure above shows, powerline device A, B and C have formed a powerline network. The user
wants to remove one device (powerline adapter C) from this network.
Step 1. Press and hold the Pair button on powerline device C for at least 10 seconds. Powerline
device C will reset and restart.
Step 2. Wait for the reset to complete.

5.3 Reset

To reset the powerline device：
Press and hold the Reset button for more than 5 seconds, and then release the button. You will see all
LEDs begin to flash. At this moment, the default settings have been restored.
Be careful, don't power off when the device is in reset process.
TL-WPA4220 300Mbps AV500 WiFi Powerline Extender
36