TP-Link TL-WPA4226 KIT Quick Installation Manual

Quick Installation Guide
* TL-WPA4226 KIT (European version) is used for demonstration in this guide.
e
r l i n
w e
P o
TL-PA4020P
LAN
Router
Extender
TL-WPA4220
2
ir
P a
Adapter
Plug in the adapter and extender in the
same room. Wait until the extender's
Wi-Fi LED
Note: If only one wall outlet is available, plug both
devices into a power strip for setup, then relocate
to wall outlets before enjoying the internet.
1
3
Pair the powerline devices.
A
Press the adapter's Pair button for 1 second.
The Power LED
Note: If the LED does not blink, press the
button again.
On
Adapter TL-PA4020P
4
Relocate the extender to the Wi-Fi "dead" zone on the same electrical circuit. Connect
your devices to the internet using the default SSID (network name) and password on the
Wi-Fi Info Card provided.
Note: If the Powerline LED is blinking, it means the signal strength is poor. Try another wall outlet.
turns on.
Attention
Plug powerline devices into wall outlets. Do not use power strips after setup.
Wall Outlet
B
Within 2 minutes, press the extender's Pair button for
starts blinking. 1 second. The Power LED
When the Powerline LED
process is complete.
Blinking
Within 2 minutes
P ai
r
Extender TL-WPA4220
Tip:
Want to unify Wi-Fi networks or
Personalize Your Network?
See the back page for instructions.
Power Strip
starts blinking.
turns on, the pairing
Blinking
On