Powerline; Network Settings; Station Settings - TP-Link TL-WPA4220 User Manual


Note:
This page will be refreshed automatically every 5 seconds.

3.5 Powerline

There are two submenus under the Powerline menu (shown in Figure 3-17): Network Settings and
Station Settings. Click any of them, and you will be able to configure the corresponding function. The
detailed explanations for each submenu are provided below.

3.5.1 Network Settings

Selecting Powerline > Network Settings, and you can configure the network name of the powerline
extender or all the stations in current network on this page.
MAC Address - The physical address of the powerline extender, as seen from the powerline. The

value can not be changed.
Device Password - The password of the powerline extender. The value can not be changed.

Network Name - Enter the network name (factory default - HomePlugAV).

Click the Default button to enter the default network name.
Click the Set Local button to set the powerline extender.
Click the Set All button to set all stations which entered the correct passwords in current network,
including the powerline extender.

Note:
If you set all stations network name, the remote ones which is powered off or entered the wrong
password will not take effect.

3.5.2 Station Settings

The Station Settings page shows remote stations in current network and allows you to enter, modify or
delete the password and name for each station.
TL-WPA4220 300Mbps AV500 WiFi Powerline Extender
Figure 3-17 Wireless menu
Figure 3-18 Network Settings
21