General Terms:
Crater
Postflow
Feeder Set Up
Auto Thread
5-2. Power Switch
Allows setting of voltage/arc adjust, wire feed rate, and time value for arc ends.
Setting a time value for gas flow after arc end.
Allow selection of Sequence and trigger functions.
Method of jogging wire without holding jog or trigger switch. Pressing Jog and Retract simultaneously
will automatically feed wire. Default setting is 192 at a feed rate of 700 ipm (these values can be
changed using a PDA with File Management/WaveWriter software). Pressing jog, purge, or trigger
switch will terminate the auto-threading feature.
1
1
Power Switch
804 587-A
OM-228 956 Page 19