Reset Mode - Miller Electric 75 Owner's Manual

5-11. Reset Mode

Enter reset mode by turning power On and pressing
the Program Push Button until the RST NO message
is displayed. RST NO message will not display until
after the power-up sequence is completed
(approximately 20 seconds).
RST
Program
Volts Time Arc Adjust
YES
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Rotate Adjust knob to change NO
to YES.
OM-228 956 Page 26
Program
Process
Wire Type
Gas Type
Process Set up
RST
Program
Volts
YES
WFS
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Press the Arc Control button to
confirm the reset.
The reset message is displayed for
2 seconds while factory program
settings are being reloaded.
During the reset mode the following
factory default programs are loaded
Program 1
Program 2
Program 3
Program 4
Program 5
Program 6
Program 7
Program 8
RST
Volts Time Arc Adjust
NO
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
Time Arc Adjust
Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
.
into the unit:
Pulse
.035 Mild Steel
90% Argon, 10% CO
2
MIG
.035 Mild Steel
75% Argon, 25% CO
2
Accu-pulse
.035 Mild Steel
90% Argon, 10% O2
Pulse
.045 Mild Steel
90% Argon, 10% CO
2
MIG
.045 Mild Steel
75% Argon, 25% CO
2
Accu-pulse
.045 Mild Steel
90% Argon, 10% O2
Pulse
.052 Mild Steel
90% Argon, 10% CO
2
MIG
.052 Mild Steel
75% Argon, 25% CO
2
.
Reset mode is not active when
Program Lock is enabled.
The reset mode allows the operator to
reload factory program settings for all
eight active programs in the unit.
.
System configuration data will be
lost during the Reset operation.
CYCL
Program
Volts Time Arc Adjust
PWR
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust Feeder Set Up
Cycl Pwr message appears on the display
when programs complete loading.
Turn power off, wait 10 seconds, and turn
power back on again to complete the reset
operation.
After Reset is complete, be sure to load
appropriate programs that contain the
correct wire size, process, and shielding gas
for the welding operation
198 993 / 804 587-A
Sequence
Trigger Control
Trigger Hold