Section 3 − Introduction; Specifications; Section 4 − Installation; Selecting A Location - Miller Electric 75 Owner's Manual

3-1. Specifications

Type of Input Welding Power
Power Source Type
40 Volts DC Axcess Series
10 Amperes

4-1. Selecting A Location

Movement
Location
Y Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
3
18 in
(460 mm)
SECTION 3 − INTRODUCTION
Wire Feed Speed Range
Standard: 40 To 1400 ipm (1.0
To 35.6 mpm)
SECTION 4 − INSTALLATION
OR
1
Wire Diameter Welding Circuit
Range Rating
.045 To .062 in 100 Volts,
(1.1 To 1.6 mm) 750 Amperes,
100% Duty
Max Spool Cycle
Weight: 60 lb (27
kg)
Tipping
2
4
18 in
(460 mm)
Overall
Dimensions
Length: 27 in (686
mm)
Width: 12-1/2 in
(318 mm)
Height: 14-1/2 in
(368 mm)
Y Do not move or operate
unit where it could tip.
Y Do not stack units. Beware of
tipping.
1 Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2 Hand Cart
Use cart or similar device to move
unit.
3 Rating Label
Use rating label to determine input
power needs.
4 Line Disconnect Device
Locate unit near correct input
power supply.
loc_2 3/96 - Ref. 804 585-A
OM-228 956 Page 9
Weight
70.5 lb
(32.0 kg)