User Reset (Jp2); Uart Select (Jp: 16, Jp17) - Fujitsu SK-8FX-TSC-32PMC User Manual

3.3 User Reset (JP2)

In case the MB2146-08-E BGMA adapter is used, the on-board User Reset button (SW1)
should be disconnected from the MCU reset input by opening JP2 to enable reset control by
the BGMA adapter during debugging.
Please check the related documentation of the BGMA adapter for details.
JP2: User Reset Switch enable
Jumper
JP2
(User Reset)

3.4 UART select (JP: 16, JP17)

The MB95330 Series MCU offers two different serial interfaces, LIN-UART and UART/SIO.
JP16 and JP17 can be used to select which interface is connected to the on-board serial-to-
USB converter.
JP16 Serial Data reception port (UI0/SIN)
JP17 Serial Data transmission port (UO0/SOT)
Jumper
JP16
(RX)
JP17
(TX)
© Fujitsu Semiconductor Europe GmbH
SK-8FX-TSC-32PMC User Guide
Chapter 3 Jumpers and Switches
Setting Description
Closed SW1 controls MCU reset pin
Open SW1 not connected to MCU reset pin
Table 3-4: Power Supply Configuration
Setting
1-2
2-3
1-2
2-3
Table 3-5: UART select
- 17 -
Description
AVcc is connected to Vcc
AVcc is disconnected from Vcc
AVRH is connected to AVcc
AVRH defined by resistor network
*1
FMEMCU-UG-90003-10