Table of Contents
Advertisement
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualified service technician.
Electrocution Hazard - Never attempt to repair or perform main-
tenance on the unit until the main electrical power has been
disconnected. Turning the unit control "OFF" does not remove
electrical power from the units wiring.
Problem
Unit not cold enough.
Unit too cold.
Noise or Vibration.
Unit will not run.
TROUBLESHOOTING YOUR REFRIGERATOR
Possible Cause
•
Control set too warm.
•
Airflow to front grille blocked.
•
Excessive usage or prolonged door
openings.
•
Door gasket not sealing properly.
•
Control set too cold.
•
Unit not level.
•
Unit turned off.
•
Power cord not plugged in.
•
No power at outlet.
•
•
•
•
•
•
•
•
•
13
Remedy
Adjust temperature colder. (See
"Adjusting the temperature control"
on page 10). Allow 24 hours for tem-
perature to stabilize.
Airflow must not be obstructed to
front grille. See "clearances" on page
4.
Allow temperature to stabilize for at
least 24 hours.
Check door alignment and/or adjust
or replace door gasket.
Adjust temperature warmer. (See
"Adjusting the temperature control"
on page 10). Allow 24 hours for tem-
perature to stabilize.
Level unit, see "Leveling Legs" on
page 4.
Turn unit on. See "Adjusting the tem-
perature control" on page 10.
Plug in power cord.
Check house circuit.
Hide quick links:
Advertisement
Table of Contents
